*click image to enlarge
*click image to view slideshow
PowrMAF 100 Installation
- The MAF should be installed in original MAF position which should has straight airflow before and after MAF and 6" from TB. Larger diameter silicone hose may be required.
- Observe flow arrow as displayed on MAF element - Open side of element must face air cleaner.
- Note * Legend is on MAF element, under connector: TB<=Air
- A-Yellow > MAF signal
- B-Black with White stripe > ground
- C-Pink > +5 V
- D-Purple (OEM) or Black > ground
- E-Tan > IAT sensor
- Make sure all clamps are secure and that there are no air leaks.
- Enter appropriate MAF table values,
found here, then run
closed loop MAF calibration
with tuning software, if possible.
